USB-SC09-FX is a programming cable which provides serial connection and RS422 signal conversion through the USB interface. Under the control of the driver running in the computer, the USB interface of the computer is simulated as a traditional serial port (commonly known as COM port), so that the existing programming software, communication software and monitoring software are used. The working power source of this cable is from USB port. It is no longer powered by the programmable port of PLC. The two-color light emitting diode on the conversion box indicates the receiving and receiving status of the data.
USB-SC09-FX programming cable for Mitsubishi FX2N/FX1N/FX0/FX0N/FX0S/FX1S/FX3U… The FX series PLC of MD8F circular socket can replace FX-232AW communication module and support maximum communication distance of 2 km.
For Mitsubishi A series PLC and all FX series PLC (including old product FX2/FX2C), please select the programming cable USB-SC09 which supports A series and FX series.
Characteristics and Technical Indicators
USB-SC09-FX Operating System: Win2000/WinXP/Win7/Win10
Programming Software Version Supporting USB-SC09-FX: FXGP/WINV1.0, GPP_V4.0, GX_Developer_V8.0 and above
Fully compatible with USB_V1.1 and USB_CDC_V1.1 specification
USB Bus Power Supply, Consumption Current About 50mA
Baud rate: 300 bps~1 Mbps standard baud rate automatic adaptation
Support UART data format: data bits: 5, 6, 7, 8, stop bits: 1, 2, check bits: odd/even/no parity
Supports long-distance communication. Maximum communication distance is 2 km (9600 bps)
Each PC only supports one USB programming cable
Working temperature: -20~+75
Cable length: 2.5 m, color: black
How to use usb-sc09
USB-SC09-FX programming cable needs to install USB device drivers to use.
When the driver is installed, the COM port corresponding to the USB-SC09-FX programming cable will appear in the device manager of Windows. It is only necessary to select the COM port in the programming software or other application software. The other communication parameters are set by default.
USB-SC09 Cable Driver
Some WIN 7 Ultimate operating system Driver not integrate well, this folder serenum.sys copied to C: \WINDOWS\system32\under drivers, you can reinstall the driver CH341.