Contents
- 1 1: Connect Power
- 2 2: Receive the wifi signal transmitted by the module
- 3 3: Set the properties of the computer’s wireless network card (IPV4)
- 4 4: Install virtual serial port software V_COM
- 5 5: Set the virtual serial port software as follows
- 6 6: Open the programming software, select the COM port corresponding to the virtual software to connect

PLC programming module wireless WIFI wireless transmission cross-regional programming
1: Connect Power
Connect a 220V power adapter or 24V DC power supply (only one of them can be selected, cannot be input at the same time, otherwise it will burn)
2: Receive the wifi signal transmitted by the module
Wifi name: wifi ETH-RS232
WIFI password: 12345678

3: Set the properties of the computer’s wireless network card (IPV4)

4: Install virtual serial port software V_COM
5: Set the virtual serial port software as follows
Click Add COM and follow the picture settings
